Accessories
| LocoNet Repeater Module LNRP |
If a wiring or signal problems occur on any “standard” LocoNet section that the LNRP is connecting and monitoring, the LNRP will act to internally disconnect the faulty “standard” LocoNet segment so that the “protected” LocoNet can continue operating.
It will also isolate and protect segments of your LocoNet layouts, extend large LocoNet installations of more than 20 devices, act as a Diagnostic tool if LocoNet network problems occur, FCC Part 15, Class B RFI compliant.
If the fault is removed, the LNRP will typically automatically reconnect and resume operations on the “standard” LocoNet segment.
DCC TrainShop $55.95
List: $69.99
|
| LocoNet Universal Interconnect Panel
UP-5 |
 Simplifies hook-up, maintenance & troubleshooting of LocoNet.
Give your layout a professionally finished look. Two RJ12 6 pin LocoNet jacks in the back of the panel for hooking up LocoNet devices that use RailSync. Two RJ12 6 pin Throttle jacks in the front of the panel
for hooking up throttles and other LocoNet devices that do not use RailSync. For example, any device that
is not connected to other LocoNet devices beyond itself. This extra throttle jack is great for connecting
a DS54 or other local device. Indicator LED that shows the power state of a local track section.
2mm power jack that allows you to make the UP5 a battery saver terminal for your throttles by plugging in a PS12 DC power supply. Rear panel has two RJ12 jacks & two #6-32 right angle screw terminals for
local track connections for power and diagnostics.
DCC TrainShop $15.95
List: $16.95
|
| R90 IR Receiver
Unit |
 The UR90 is the IR receiver unit. The UR90 also looks similar to a UP5 and is
mounted in the fascia of the layout. The UR90 is simply an addition to your existing LocoNet
so no additional wiring is needed. The UR90 will support approximately 10 Infra-Ready throttles
(DT100, DT300 and DT400 series). Most layouts will need more than one UR90 because IR is line of
sight and the receivers must be able to "see" the IR signal. UR90 & UR91 can be used together on your
layout to provide both wireless methods at the same time. If you already have DT300's or DT400’s the
UR90 is the only thing you have to add to get infra red throttle operation. PS12 power supply or equivalent required.
DCC TrainShop $34.95
List: $45.95 |
|
UR91 Radio/IR Receiver Unit |
 The UR91 is the radio/IR receiver unit.
The UR91 looks similar to a UP5 and is mounted in the fascia of the layout.
The UR91 is simply an addition to your existing LocoNet so no additional wiring
is needed. The antennas are concealed under the layout. The UR91 will support approximately 10 radio throttles. Most layouts will need just one UR91 but in
some large configurations a second unit may be needed to compensate for "dead" spots.
This unit is also equipped for concurrent infrared operation using all Digitrax IR throttles.
PS12 power supply or equivalent required.
DCC TrainShop $114.95
List: $149.99 |
|
|
